Yes it did turn on it's own and would reverse via the VFD controls, and the speed would adjust up & down. If not, you most likely don't have the motor parameters in the VFD set correctly. I'll bet the motor sounded funny too right? But it did TURN on it's own? That is baby step #1.īaby step #2 is turn the frequency up and down to see if the speed changes as it should.īaby step #3 is to put a light load on the shaft (I used a shop towel and my Kung Fu grip © ) to see if it has any torque. Give it your best effort and if it isn't working find someone locally who can help you with hands-on. We have our own problems to deal with too and can't spend ALL our time at the keyboard. We try to help with problems if we can but we can't do it all for you. As was mentioned previously we aren't trying to be mean but we can't hold your hand every step of the way. You need to learn how to do this on your own NOW because you will need to be able to make changes as needed later on too. Every parameter is described in your owners manual. (01-24-2018, 02:18 PM)Highpower Wrote: (01-24-2018, 11:54 AM)sun20ma Wrote: can anyone tell me the parameters I AM LOST WITH THE SOFTWARE Grizzly lathe G0602 with a Automation Direct GS2-11PO only using it's keypad with a Leeson 192051 1800rpm 3 ph 230v
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |